Hi
I dumped from a dead switch the savegames with tegraexplorer script: dump_saves.te
How can i restore the bunch of 800000000001 (System) and 000000000001 (User) files into another CFW switch ?
Would it be sufficient to simply copy them into another nand in the same directory using...
A few ppl and me have the same problem. If you boot into OFW you will get a bluescreen ?
(On "NO SD" Screen - Press Vol - & + together)
Did you have try to rebuild a "donor" nand and restored on your switch ? Possible only if you got befor your biskeys.
We are concerned that the content of the...
No reball, as I don't have a decent BGA system.
I took the DAT0 adapter and have already exchanged it for another one. Unfortunately, the problem is still the same. The question is, why did the switch crash shortly before the end when creating the Nand ? Maybe a short circuit between DAT0 &...
Did someone know how i can get my biskeys over IRAM ?
CFW (Hekate) = Blackscreen and OFW = Bluescreen.
Ums-loader via IRAM = Works (and I can also dump Nand.)
Firmware 2.75 maybe fix this issue too:
No, a hardware fault can be ruled out. I installed the chip as usual and the device had also started and I entered into Hekate. However, it got stuck after about 20 minutes when creating the Nand backup. The screen was full of graphic artifacts. I know that this happens when the DAT0 is not...
Hekate, lockpick_rcm and biskeydump = Blackscreen
OFW = Bluescreen
Does anyone know how else I can get my Biskeys? Thx!
Only ums-loader works as payload.bin maybe this only works because it is started from memory.
I got now over the ums-loader and nxnandmanager my nand dump but i still need my biskeys for decrypt it.
If I start lockpick_rcm or biskeydump both renamed as payload.bin over the pico chip i got still a black screen.
Does anyone know how else I can get my Biskeys?
Hekate, lockpick_rcm and...
Yes here the same - RP2040 OLED Installation - At the NAND Backup over Hakete the screen has freeze at 83% and now OFW allways in bluescreen. The RP2040 works fine but don't start anything from SD.
CFW = Blackscreen
OFW = Bluescreen
Caused maybe by a short circuit at Dat0 and Dat1
Anyone know...
Dear Rehius
The v2.74 was stable with old OLED NAND from manufacturer SEC but recent OLED revisions like from Switch Zelda Edition it is really unstable. So the issue is again like from CORE toshiba nand timings.
I replaced the resistors but the "EMMC Slower Mode" problem was still there.
I used the same resistors on a Waveshare RP2040 and that solved the problem.
Why doesn't it work with this chip ?
The points must all without any resistor but if you got this after installation and booting a CFW
Then you ran into the "Slow EMMC" Problem.
- Pull out QSB-Flex from the chip
- Remove possible resistors on the points or leave the resistors with 470
- Add 47 Ohm (470) to DAT0 (C)
- Add 47...
Does anyone know why by factory setting has this RP2040 by Team HWFLY at Point C (DAT0) 200 Ohm and RST 47 Ohm extra added ? Also is someone know where I can connect alternative CPU wire (Without Flex) ?
Thx
I may try the new ram site, and download more RAM to my Switch. Not sure if ddr3 is the right ram
for it tho. Edit- no it uses floppy Ram, just like @AncientBoi