ps5 edm-010 eternal reboot in safe mode

[Sanickpk]

ps5 turns on and immediately asks to connect the dualsens via wire and press PS, and when you press PS the console reboots to the same screen, and I noticed that the RAM banks immediately heat up. What could be the problem? All main supplies 12.5, 3.3 V are present.

 

[jkyoho]

ps5 turns on and immediately asks to connect the dualsens via wire and press PS, and when you press PS the console reboots to the same screen, and I noticed that the RAM banks immediately heat up. What could be the problem? All main supplies 12.5, 3.3 V are present.

reset/restore system been tried?

 

[Sanickpk]

reset/restore system been tried?

They cannot enter this mode; when you press the ps button, the console restarts to the same screen

Post automatically merged: Sep 30, 2023

after turning on the console, 5-10 seconds later heating occurs on the RAM banks

 

[Johnny_debt]

Wifi / bt module can't connect the controller because it is faulty and causes a reboot? When you get to that screen can you hold power and shutdown without any issues?

 

[Sanickpk]

Wifi / bt module can't connect the controller because it is faulty and causes a reboot? When you get to that screen can you hold power and shutdown without any issues?

I managed to enter the recovery menu by accidentally shorting this cap with a multimeter while checking the voltage, in the photo I had already unsoldered them and they turned out to be fine (small at 1uf, large at 10uf)I think that the chip responsible for the ssd or the ssd banks themselves are working properly, my power supply to them is 2.5V, right? or it should be 3.3V. I just can’t find how much should go to these capacitors.

 

[Johnny_debt]

I managed to enter the recovery menu by accidentally shorting this cap with a multimeter while checking the voltage, in the photo I had already unsoldered them and they turned out to be fine (small at 1uf, large at 10uf)I think that the chip responsible for the ssd or the ssd banks themselves are working properly, my power supply to them is 2.5V, right? or it should be 3.3V. I just can’t find how much should go to these capacitors.

Its 2.5v and comes from pmic that powers ssd controller and ssd modules.

 

[Sanickpk]

Its 2.5v and comes from pmic that powers ssd controller and ssd modules.

Here is the video, and at that moment when I forgot to turn off the auto mode on the tester and it switched to beep mode, after that the 2.5V voltage disappeared and I was able to enter safe mode

 

[Sanickpk]

and so I got the safe mode to start, I can reinstall the firmware and it will install without errors, but after everything is installed the ps icon appears and says console storage repair 20%, then suddenly 100% and the message something went wrong!
What was done: first I replaced the ssd controller, but this did not work.
After reballing the 3 upper ssd cans, I was able to enter safe mode, and then the 3 lower cans were rerolled!
Which ssd banks can be transferred from a donor?