the dat0 point is on the back of the motherboard (green wire to the left), so we can't tell from these pictures. But considering that the installer used the d/a/c flex cable he probably used a shitty dat0 adapter as well.
depends on your iron and your tip. Mine is at 380 when wicking motherboard and 330 when wicking emmc. The most important step is to mix the balls with low-melt solder first though, by creating a blob of low-melt on your solder tip and running it...
the hell dude. you've had your temperature set way, way too high when wicking.
however, the pads that have fallen off aren't connected to anything, so it should still work.
you cannot put solder balls on the pcb - the stencil will not fit. you...
You my friend have the bestest English.
I'll do an attempt at translating for the others:
"Is this chip custom made, and delivered assembled and ready to be programmed? Not possible to purchase on Aliexpress?"
The answer is: Yes. You use the...
part of the issue is that flash carts and similar producs always have been advertised as "for playing personal backups only" while they've been super simple to use with piracy - only in this case, people assume the backup statement is just for...
I may try the new ram site, and download more RAM to my Switch. Not sure if ddr3 is the right ram
for it tho. Edit- no it uses floppy Ram, just like @AncientBoi