That is normal. If those lines are actually short you won't be able to boot to a white light. You should focus on the hdmi circuit. There is a 100nf cap on pin 18 and a zener diode. Please post all 19 pins diode reading (red probe on ground) from the hdmi port, use a hdmi breakout board if...
If you remove the ssd controller and the the short to ground is gone then it's the ssd controller causing the short no? What is the resistance to ground with the ssd controller installed?
Did you thoroughly clean out the flux and ipa from under the SB? Usually when it hangs after installing a known good working SB it was the flux and ipa under the SB (on the solder balls) that's messing with the crystal oscillator causing it to hang. I would heat up the sb area then flush ipa...
I had one that had the same error crash code whenever in game for 5 min or so. Uart doesn't show any errors from game crashes for this. Unfortunately I haven't been able to fix these, seems like apu / ram / on board ssd related.
I know the pricing of electronics nowadays isn't "how much it actually costs" but "how much we can get away with", but putting up a poll is just cynical.
Nah I'm getting value creep again. I look at a $50 console "but for just a few more dollars you could get XYZ" and I end up considering the Steam Deck.
is sega just personally fucking with me? are they laughing while watching me through my kinect camera as i get up to restart my xbox for the third time because the game froze again