This is not joycon side problem. This is motherboard side. All the joycons i have plugged in were already fully charged and the device keep indicating charging despite of that.
The battery is full. It has been charged for a wholeday already after i fixed the previous problem. There is nothing on the joycon side. This one is the motherboard side.
After 1hour of finding a fix for left joycon not charging at all(the problem came from missing 5v). Now i meet with another problem after the previous one. The joycon now charging endlessly but when attach to another device it shown full already. Do any one know which part on the mother board...
This one is not the orange one i shared in the picofly thread. That orange one was nofix,the board has been tampered all places already before i got my hand on for 5$. If your device works before maybe you didn't replace the ic wifi correctly, try once more.
From 17.0 + you have to launch the console in syscfw first after doing unbrick (sthetix method). Did you try it? If you have tried it but no result then it definitely hardware related. To check this you can run android to test. If the console can use android mean that your emmc issue , if not...
If it was joycon logo that meant your emmc is good with full partitions already. You have good cpu and emmc. Change another wifi ic and make sure it a good one.
You mean stuck on logo? Is it joycon logo or it show nintendo letter then shutted off. If it was joycon logo, your switch has full partitions on emmc already. Try to replace the wifi ic if it was the case.
If it was nintendo letters then shutted off , it meant your console only has boot0,boot1...
This is the first time i have met this one. The console has wifi but no bluetooth(the wifi work perfectly). I have met this similar case from oled one but that time it was a bridge the modder made. But now this v2 one has no bridge near the ic.
I have changed 2 ic already the problem persist so...
I have fixed this case one. The console sometime could boot to hekate and freezed at some point sometime showed crashing image. My case was dram . you have to take a gamble between cpu and dram good luck.
Do the console boot without the chip? If not check the 3.3v rail if it is shorted or not. If it is not shorted check the voltage when you plug the power cable in to see if the 3.3v rail give you 3.3v or not. If it is not then check your 3.3v regulator.
1712549766
Maybe you can switch to use...
I may try the new ram site, and download more RAM to my Switch. Not sure if ddr3 is the right ram
for it tho. Edit- no it uses floppy Ram, just like @AncientBoi