what motherboard version do you have why is r7d3 connected ??
why solder on the bottom of the board ? u only need to connect the jtag to the point above tha cap wich you did
chek the soldering if there is a connection , no need to connect anything at the bottom of the motherboard
r7r3 need to be bridge ,after that just reconnect the original hdd en disc drive put in the autoinstaller i should work
flash the tsop with a 256k bios
I see he has a sharp in pic above. Sharp is 1MB flash and not 256kb
Step 1. identify your motherboard revision
Step 2. identify your tsop chip type
Step 3. bridge tsop point(s) usually 1 or 2 only
Step 4. now you can flash any bios and upgrade to 16tb if wanted
thank you both for your answers
its a 1.1 with sharp and i didnt even come to the point of flashing after i soldered both connections and jumper wire the xbox wouldnt output any video signal and disc drive made a weird clicking noise
i followed the how to on https://consolemods.org/wiki/Xbox:TSOP_Flashing
r7d3 was bridged on top and bottom since that what the how to told me + the jumper cable was needed only for sharp models
here are the pictures i followed after:
and