A broken Dat0 via while doing a kamikaze will result on a black screen when you power on the Switch. i can see that your Dat0 via is very well exposed (perfect circle) but what about the thin line wich goes to CPU? Are you shure you didnt broke...
i would advise you to get rid of those crapy chinese adapters and solder wire directly to motherboard point to pads on the chip .That way is easy to check all conections.
Yes, thanks, it was pulsing green. But I’ve read that sometimes, after major firmware upgrades, the chip may go “out of sync”. They suggested me to reset the mod board and everything started working again. :)
hi. Updating your stock firmware wont do any arm to your modchip. I bet you did change something to your harmod (modchip) that you forget to told. What is the error code ( green light pulsing) ?
Lollll, i was just thinking the same thing :D. it is a lot easier to do it with a thin wire. Done more then 30 kamikaze with just a stripped thin wire without any trouble.
I replaced the MAX7780 1EWP voltage regulator with a new one and the console is back to life. No more errors or weird behavior during glitching or after. Will test it for the next few days to see how it behaves, Thanks @superxoi @abal1000x and...
I'm sure you created a short circuit during the trial and error process of your installation. There are more than 30 installations in Oled versions that I only use single-sided installation and always with kamikaze mod. This way you reduce the...
Good news everybody, Atmosphere and Hekate have both been updated for FW 18
https://github.com/CTCaer/hekate/releases
https://github.com/Atmosphere-NX/Atmosphere/releases
i have a question currently my atmos switch isnt picked up by pc on HOS but the cable and port do work with apx and tegra so i know the hardware is good, any clue?