I will order a new 64 GB chip from Ali just to be sure it will be ok... because the old one has had too much heat... I will send you also the 128 GB to see if you can also write the image there.... maybe I ruined it also... (I don't know...) so I have to wait for the chip and I will contact you...
The problem is that i don't have a programmer to write the image... I have kept Boot 0 , Boot 1 and a whole image of the original nand... I have tried the new emmc and nothing....it gives me yellow light error...not even trying to glitch...
So i have an update....
Finally, the nand stencils arrived so i reball the original nand chip to give it a try, i solder it back and now i have a blue light trying to glitch and after 40 -50 seconds turns to white and again blue flashing about 40-50 secs and 3 yellow at the end and stops... 1...
Since i have a backup of my NAND, I bought a new chip to replace the corrupt one... I also bought an RP2040...
I have changed the NAND I have soldered the new empty NAND chip but the RP2040 cannot boot with an empty emmc chip...
I have read that to glitch it needs BOOT 0 and BOOT 1 partition...
Hello, I have a backup from my original OLED Nand chip (which is dead), I have replaced the Nand but I cannot boot into HEKATE...
I have an rp2040 modchip and when It tries to glitch it gives me this error (=** eMMC init failure during glitch process) ... can with this modchip somehow run Hekate...
I am in the same situation... but I have kept the NAND backup before it dies...
I have changed the NAND, I have that same rp2040 chip but it gives an error (=** eMMC init failure during glitch process)
So is there any way to boot HEKATE with a clean EMMC chip with rp2040? (is there any rp2040...
I have an Instinct NX v6 chip and my nand got corrupted... I have read that with og HWFly modchip, you can use Hwfly nx firmware which allows for glitching into an empty - corrupt Nand and you can restore it with hekate (if you have made a backup before)... I have made a Nand backup will the...
Hello guys, I have an oled and I had a problem with a corrupt NAND...and blackscreen...
as I am searching to find a solution I discovered a short in the board...
Can someone test it on the working board to check the value... It is near Realtek ALC5639 chip...Can I remove it??
Is this cap...
I hope someone can help me...
I modded my Oled Switch (3 months ago) with INSTINCT NX V6 and it was working fine... as I was playing it froze and gave me an atmosphere error screen... I turned it off and after that, I had a black screen….
After some attempts, it finally booted to Heakte and I...
I am in a similar situation... If you have a corrupted emmc chip and a black screen, is there any tool to restore my emmc backup? Does the ums-loader work with Instinct-NX?
I've been playing fallout4 all day, I went into a elevator and it kept going, never stopped, waited 5 minutes, must of been a bug. How bout you, whatcha do today?