Search results

  1. K

    Hacking Hardware Picofly Oled Switch turns off everytime it enters sleep mode

    I installed picofly on an oled switch, and it seems to be rebooting the firmware everytime it exits from sleep mode via the power button. Waking it in other ways like by removing or inserting the SD card will not cause this reboot. Thanks for any help <3
  2. K

    Switch boots only in cfw

    SOLVED: Fuse mismatch I have a nintendo switch that was updated to 17.0.0 in sysnand, it can no longer boot OFW but it will boot CFW in SysNand and EmuMMC. This is how hekate_ipl.ini was setup: What could I do to fix this? I don't have a backup for this. I only have the keys, and automatic...
  3. K

    Hacking Hardware Picofly eMMC test failure - read failed

    Brand new modchip installation, I'm getting =*== eMMC test failure - read failed. It's an OLED switch, boots fine in OFW. I used the alternative Dat0 soldering point by grinding through the layers. I know I didn't damage anything because as I said it works well in OFW. To debug it I've...
  4. K

    Hacking emmc initialized in slower mode - 2019 model

    SOLVED - Had to replace RST resistor and change the CMD and DAT0 resistors on my picofly for 100 ohm resistors I've installed picofly on a 2019 model switch. It seemed to work smoothly, only to realize that while performing the backups it started popping out warnings about emmc being in slow...
General chit-chat
Help Users
  • No one is chatting at the moment.
    Psionic Roshambo @ Psionic Roshambo: https://www.youtube.com/watch?v=iIpfWORQWhU