Thats right, but others said its worth trying…and i love soldering so its not wasted time. And in the end i learned a bit…even if its not improving glitch-time.
OK, so I think the main problem with my long glitching-time is in fact the apu-flex-cable. I will replace it with a single-mosfet install and give feedback.
I just installed this Instinct V6, and it's displaying this combination. The first time I turned it on, it booted into the original system and then turned off. Now, it won't turn on anymore; it just keeps blinking but won't power up. Can anyone...
Hi there. Do you have V6 or V6S? With V6S there is a toolbox available. I think this should work for V6, too.
Otherwise you have the option to reset training data from the console. Simply connect the chip per USB to your computer and open a...
...and rst scraping (if you dont want to lose the advantage of assembing) :) But everything of these is easier to fix than an overheated EMMC, isnt it? Maybe Im a little bit too much afraight because I have no experience in desoldering and...
Hey guys. After many modded oleds i am asking the question to myself which way is the best to connect Dat0 to the modchip.
I started with a simple friction Dat0 adapter and never hat problems with it…but i was never happy with such a connection...
I've come across a few switches that wouldn't glitch with only one wire to cap/gnd. with two to each it worked. so now i do both sp1+sp2 just in case the switch won't glitch with just one. easier to spend an extra minute (often unnecessarily)...
In my experience, glitch time is mostly related to the mosfet setup. I've tried all combinations of everything (mosfet on front, back, double or single, different wire thickness, wire length etc) and the setup that I find performs the best...
All pins on the joycon are currently assigned but there are 3 GND pins.
Never can't have too many GND signals I guess.
You could reassign one of the GND pins for the signal to the LED.
You would need to cut the traces properly though.
Both on...