Recent content by xstre pwnsx

  1. X

    240p at 60hz for 240p capable wii VC pal titles (NEEDS TO BE IN PAL) I'm using NTSC wii w/ SCART

    I'm sure this could be confusing, but I am using SCART on an NTSC wii to get RGB by forcing video modes, or using pal region software, I usually do this through priiloader or usbloader for GC games. My dillema is I can't figure out a way to run 240p capable virtual console games at 60hz. Would...
  2. X

    Hardware Switch Repair Advice being sought

    Thanks for all the advice.. say I've made the mistake of plugging in both emummc modules and tried to boot at some point, would I not still be able to get the unit into RCM mode (They are both unpatched)...
  3. X

    Hardware Switch Repair Advice being sought

    Also is there a way to tell which emmc module goes with which motherboard? I seem to have mixed two modules up... or rather what happens when you plug the wrong emmc module in.
  4. X

    Hardware Switch Repair Advice being sought

    Some good news I removed that cap on m92 pin 18 and the pads don't short... so the capacitor was bad! would anyone happen to know where I could pluck one off a donor board to replace it with (minus the exact same spot as I've taken that one already)
  5. X

    Hardware Switch Repair Advice being sought

    @Mightyjebus Pin35: ~0.94V ----> Charger rotated 180 degrees Pin 35: ~0.11V Pin37: ~0.11V ---> Pin 37: ~0.93V Fluctuated from (0.08V to 0.11V) Fluctuated from (0.93V to 0.94V) Battery Connector on PCB Pin1 (from left)...
  6. X

    Hardware Switch Repair Advice being sought

    2 of the large capacitors under the CPU are shorted....
  7. X

    Hardware Switch Repair Advice being sought

    I purchased a nintendo switch to repair; I came here to ask for advice about what may be wrong with it. Board: PWB/ AU/ CHN HAC-CPU-01 Fuse has continuity The battery does not charge, I plugged it into the usb c charger w/ battery and left it for 30 minutes result being battery went from 4.06v...
  8. X

    Hope you're doing well matty.

    Hope you're doing well matty.
  9. X

    Hacking L4T Ubuntu - A fully featured linux on your switch

    One thing I've noticed since they've updated to the latest version is that the joycons work when attached on the rails w/o bluetooth.
  10. X

    Hacking Team-Xecuter Solution coming soon for latest Switch models

    If this is real it's time to sell my hard modded launch switch before it's value tanks, and get me a mariko.
  11. X

    Hacking WIP [Trinket] [Rebug] [Others] SWITCHBOOT_UF2 / FUSEE_UF2 modchip software

    @mattytrog I wired up an itsbitsy with switchboot on it, right now it's behaviour is flashing red lights and boots into normal horizon with pwr button, pwr and volume + goes to a black screen. I checked to see if I could flash over usb and at one point I could view the switchboot folder, but...
  12. X

    Hacking WIP [Trinket] [Rebug] [Others] SWITCHBOOT_UF2 / FUSEE_UF2 modchip software

    Thicker wire on the whole modchip, or just the joycon strap? I'm having issues as well with thin magnet wire.
  13. X

    Rare gaming accessories you own. Good and bad ones.

    Were there any games that actually used this, or is this a purely aftermarket thing for homebrew?
  14. X

    Sony is now opening up cross-play on PS4 to all willing developers

    Great idea, it always bothered me that crossplay between consoles wasn't just a standard thing.
  15. X

    Red Dead Redemption 2 is coming to PC

    This release will have online yes, I've been considering picking up this game can anyone tell me if the online is actually fun?
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    bassviolet @ bassviolet: uwu