This gave me the idea to modify the top-part of the rail, like drilla hole and put some paperclip through it, remove some of the sides and bend the clip so it would connect the outer pins. So you can just turn the joycon around. Wonder if that would be possibleBam.
Hacking Obvious, but be careful putting things in your joycon rails
The exact same day this hack has been revealed I had to get a pair of new joycons! (Right was ok by left started to act up a bit). I soldered the old right joycon only for the purpose of the hack and I think it is the safest way to go about it: You can replace the joycons (great innovation for an handheld btw) but you cannot replace the switch!
I have had toilet paper stuck in my right rail for a couple years, but not from trying RCM, I just had a broken joycons so I put it in there to even it out so that both could be "connected" (while still wirelessly) and now it's stuck and I can't get it out. I've tried tweezers, knife, duct tape, toothpicks, etc and I cannot get it out because it's lodged too deep.
You should be able to access it from the inside, the little board with all the pins is actually removable if you open the Switch, which should allow you better access. If all else fails, replacement rails are not expensive.
Similar threads
