Hey together.
I modded an old Switch OLED with Samsung EMMC. Glitching works well and fast, but sometimes (about 1 out of 15) glitching fails and gives **= (No eMMC block 1 read (should not happen))
Has anyone of you had a similar or samne problem?
This setup workes fine for SkHynix and newer Samsung but on old ones sometimes fails.
Setup:
Picofly
0.1mm wire (RST, DAT0, CLK, CMD)
0.2mm wire (VCC)
v6 APU Flex-cable (CPU, GND)
I modded an old Switch OLED with Samsung EMMC. Glitching works well and fast, but sometimes (about 1 out of 15) glitching fails and gives **= (No eMMC block 1 read (should not happen))
Has anyone of you had a similar or samne problem?
This setup workes fine for SkHynix and newer Samsung but on old ones sometimes fails.
Setup:
Picofly
0.1mm wire (RST, DAT0, CLK, CMD)
0.2mm wire (VCC)
v6 APU Flex-cable (CPU, GND)
Last edited by superfiege,