i have 2 oled with instinct but the older oled 2023 dont have this issue and the new one 2024 oled has, what happened?normal
i have 2 oled with instinct but the older oled 2023 dont have this issue and the new one 2024 oled has, what happened?normal
It happened to me on 2 OLEDs with picofly RP2040-ZERO
When I enter the EMUMC partition, the official system and Syscfw system I watch the screen show two white color lines....
yes but I want to know why this happens because not everyone experiences it even with same chip or notIf you go and check previous messages they already mentioned that it is normal.
If you want to know, then you need to buy some Logic Analyzer or Oscilloscope then you need to find a way to clip pin in the oled connector, and find some unusual signal. Then you trace back what line produce those unusual signal, it will ended on some ic or resistor or capacitor. You test one by one, maybe by removing it, and check whether the unusual signal produce or not. Then you found your 'reason'.yes but I want to know why this happens because not everyone experiences it even with same chip or not
I will try and see.please clean your oled display ribbon and connector
This flex?Does anyone know where to get the new kamikaze flex picofly? I checked all over ali
Does anyone know where to get the new kamikaze flex picofly? I checked all over ali
Lollll, i was just thinking the same thing . it is a lot easier to do it with a thin wire. Done more then 30 kamikaze with just a stripped thin wire without any trouble.It doesn't seem any easier or cheaper than just running wire. So what's the benefit? Is it faster?
To me it just looks like an easy way to accidentally rip DAT0 point.
It doesn't need cutting on the OLED. Fits perfectly next to the heatsink on top of the ram.Is it possible to close the Nintendo Switch OLED with the installation of RP2040 Zero, without cutting the shield?
Thank you, guy.It doesn't need cutting on the OLED. Fits perfectly next to the heatsink on top of the ram.
It doesn't depend on the modchip, in my case (RP2040-zero) I thought it was the modchip that was the problem and I replaced it but nothing has changed.yes but I want to know why this happens because not everyone experiences it even with same chip or not