I need some help! I was modding my fiancé’s old GBA SP and it wasn’t charging properly. The port was loose. So I figured I’d replace it since I had the part. It was pretty stuck and I ended up removing the pads on the charger port on accident. Is there any way I can fix this? The gba still works with a battery in. It would be unfortunate if I can’t charge it normally though. Does anyone know where each of the 6 pins can be rewired to? I ordered a USB C charging mod for it as well. That only has 1 solder point besides the anchors. Where would I solder that to without a pad? I feel it’s possible to fix this mistake but I’ve searched endlessly and feel like I’m the only one that messed up this bad with the pads. I also messed up ROUT’s pad but oh well on that. I just want to be able to charge again. Does anyone know specifically which pins need to be wired to charge?