Help me dilate a tight hole

[JuanMena]

Guys guys, I need your help.

I'm trying to make this hole bigger but no matter what I try it's not getting any bigger to fit my cable.

The idea is to fit the black cable through the tight, tiny hole in that sleeve, so I can solder it to the 3.5 jack.

I've been also doing like I do to y'all mums, but spit and spanking isn't helping either.

What should I do?

 

[SylverReZ]

Guys guys, I need your help.

View attachment 436123

I'm trying to make this hole bigger but no matter what I try it's not getting any bigger to fit my cable.

The idea is to fit the black cable through the tight, tiny hole in that sleeve, so I can solder it to the 3.5 jack.

Consider getting replaceable jack plugs, which can be easily removed and soldered to.

I've been also doing like I do to y'all mums, but spit and spanking isn't helping either.

You failed to sex.

 

[Veho]

Sound like boring work

 

[JuanMena]

Sound like boring work

Actually these earbuds sounds really bad

 

[tomberyx]

Use Hot-Gun !

 

[JuanMena]

Use Hot-Gun !

I kinda used that idea.
What I did was to insert the sleeve in a pair of thin pliers, and heat the other end with a lighter. It did worked.

Unfortunately, these earbuds sounds really bad.

 

[CoolMe]

Unfortunately, these earbuds sounds really bad.

No amount of dilating will make them sound good

 

[JuanMena]

No amount of dilating will make them sound good

That's right!
It's because those earbuds are cheap... like Luke94's mum.

 

[CoolMe]

That's right!

Then are you wasting your time with it? Time to upgrade to something (IEMs or some decent cans)

It's because those earbuds are cheap... like Luke94's mum.

Now now

 

[Hayato213]

You failed to sex.

 

[tomberyx]

1. Use Hot-Gun
2. Use something to spread the Hole (Metal-Tube or Pencile but no Sex-Tools)
3. You know what to do next

 

[slaphappygamer]

Hold the far end of that cable with one hand. Then, with the other, pull the wire jacket away (towards the end you wish to solder). The friction from your hand running down the cable multiple times will warm the jacket. The jacket will begin to stretch passed the end of the wires. Now, you have an empty jacket at the end. It should be a slightly smaller diameter and you should be able to insert the jacket into the boot. Then, when you have enough jacket in the boot, you can begin (I haven’t tried this, but it should work) to cool the jacket with ice(?). The jacket material should relax and you would have access to the wires now inside the boot.

OR

Use heat shrink on the wire. Insert only the wire (not the jacket) into the boot and perform your task. Then, pull the heat shrink over the boot and heat it up. Not as clean, but will get the job done.

MOAR OR!!

You can snip the very end of the boot. Snipping the very end of the boot will allow you to gain the right diameter for the wire. The end of the boot is conical. Making the boot shorter will allow a wider wire.

 

[JuanMena]

The friction from your hand running down the cable multiple times will warm the jacket.

I better use my good hand for this.

 

[slaphappygamer]

I better use my good hand for this.

Oddly enough, your wrong hand may be the right hand to use. Using your normal hand (I don’t know if you are righty or lefty) your gription is conditioned as you’ve use that hand for hundreds of decades. Your wrong hand doesn’t have this condition and you may get better gription. Wearing gloves will also have this effect.