i have 2 oled with instinct but the older oled 2023 dont have this issue and the new one 2024 oled has, what happened?
When I enter the EMUMC partition, the official system and Syscfw system I watch the screen show two white color lines time appearance logo atmosphere logo and show the official Netindo screen logo and does not appear something checked Points and check DAT0 cleaning Motherboard Nothing There is nothing but this thing is not separated if you separate the CPU Point wire in the RP2040 CHIP widget ... Please answer this error in Boot Chip.
Cfw ofw emummc 18.0.1 hats pack 17.0.3
I have video.. You can see one line frist inter emummc and after logo atmosphere...
Cfw ofw emummc 18.0.1 hats pack 17.0.3
I have video.. You can see one line frist inter emummc and after logo atmosphere...
Last edited by Danook28,
If you go and check previous messages they already mentioned that it is normal.
yes but I want to know why this happens because not everyone experiences it even with same chip or not
If you want to know, then you need to buy some Logic Analyzer or Oscilloscope then you need to find a way to clip pin in the oled connector, and find some unusual signal. Then you trace back what line produce those unusual signal, it will ended on some ic or resistor or capacitor. You test one by one, maybe by removing it, and check whether the unusual signal produce or not. Then you found your 'reason'.
For me, thats wasting time. As long as its work, and not interfering with me enjoying the game, then all is good.
Attachments
It doesn't seem any easier or cheaper than just running wire. So what's the benefit? Is it faster?
To me it just looks like an easy way to accidentally rip DAT0 point.
To me it just looks like an easy way to accidentally rip DAT0 point.
Lollll, i was just thinking the same thing
. it is a lot easier to do it with a thin wire. Done more then 30 kamikaze with just a stripped thin wire without any trouble.
It doesn't need cutting on the OLED. Fits perfectly next to the heatsink on top of the ram.
It doesn't depend on the modchip, in my case (RP2040-zero) I thought it was the modchip that was the problem and I replaced it but nothing has changed.
Among other tests, I also removed it and the console no longer showed the line.
Of course I checked the flat video as well... perfect. In my opinion it's a bug in the code on the video refresh because it appears when the video is reset on the screen
Similar threads
-
-
-
-
-
-
-
-
@
realtimesave:
the one on my mercedes is a couple years old. these things don't last very long at all+1 -
@
BigOnYa:
Are you near sea/salt water, or in general they just don't last. Sounds like if you driving a mercedes, you need a garage. I get snow n ice here so nothing worse than clearing that shit off at 6am rushing to get to work. -
-
-
@
BigOnYa:
Immigrants took over your garage? I hate those
swatters. Or is it Kilos waiting to be picked up by Carlos. Lol jk -
-
-
-
-
@
K3Nv2:
Still two wire with resistor if you don't count the 7 wire pc probes cause hardware likes a good probing+1 -
-
-
-
-
@
realtimesave:
I tried to get a slim on a black friday once, but they ran out of stock for the $100 one
-
-
-
@
K3Nv2:
Still remember grabbing this ps4 slim on black Friday for $200 when the msrp was still around 300+1