reboot and go to pico toolbox again?Removed usbc and Installed picofly 2.65. updated to 2.67 using toolbox, succes.
But how can we confirm if it is actually 2.67??
reboot and go to pico toolbox again?Removed usbc and Installed picofly 2.65. updated to 2.67 using toolbox, succes.
But how can we confirm if it is actually 2.67??
shutdown and boot into hekate, launch toolbox again and select infoRemoved usbc and Installed picofly 2.65. updated to 2.67 using toolbox, succes.
But how can we confirm if it is actually 2.67??
yes i updated the picofly to 2.67 with the toolbox usin update.bin ..every payload launch flawlessly except fusee.binRemoved usbc and Installed picofly 2.65. updated to 2.67 using toolbox, succes.
But how can we confirm if it is actually 2.67??
My unit suddenly can't glitch to payload. It always boots to OFW as if not modchipped. I can see blue led then green led right before the Nintendo logo shows. Already tried without sd card and still the same.
Do I need to return this now to the shop that modded it?
Edit: Modchip is Rp2040-zero 2.65fw.
Damn, we all kinda knew this was gonna happen. But for real, not that soon :shocked:AliExpress is starting to sell them now lol
https://www.aliexpress.us/item/3256805289070238.html
Current price is 12 to 13 USD for just the board and 18 USD for the board with the flex cable.
If you want it to fit it needs to be cut
Thanks, another question. In the pi pico when I remove the transistor I need to replace with de 47 ohmz resistor or bridge the resistor points with only one side of the 47 ohmz resistor?
looks good to me, dude. good luck!I thought it would be difficult, but this mosfet is Hard level, but I think it will work
View attachment 367842
I'm going to need a lot by the way. Thanks!!looks good to me, dude. good luck!
did you try jumping the rgb / grb led mode pins on underside fo RP2040.Have a Waveshare RP2040. Was able to upload the firmware without any problems. Strangely, he gave no LED signal. Now I have installed the chip anyway but it does not work. The chip is dead. No LED display and the switch does nothing. When I disconnect the chip, the switch boots normally.
Can I assume that the RP2040 is defective? Unfortunately I don't have one left to test.
I am not the only one with such a problem.
https://gbatemp.net/threads/picofly-aio-thread.628951/post-10134317
What is meaned with "shorted the detection pins"?
Great job.Hi.. done on the first try.. huihh, it took almost 6 hours. Using one mosfet fdmc7672 and pi pico.
Post automatically merged:
i solder the mosfet on the heatsink ground.