hey, I have a problem with installing picofly on a v2 switch I used a hwfly pico with a flex cable. When switched on, the chip flashes blue then yellow. Without an SD card I have the "no SD card" screen but when I put an SD card prepared with Hats 1.6.2 the chip starts in the same way but the screen remains black. sorry for the limited english i translate my french with google
picofly black screen with sd card / no card sd screen without card
- Thread starter jimbow02
- Start date
- Views 3,143
- Replies 14
how then tried to start in ofw? should I unplug the chip? and put the nand back in its location without the chip? I'm sorry these questions may be stupid but I'm a noob on these installations and I prefer not to do anything stupid here are some photos of the chip used.
Attachments
It's likely your eMMC isn't properly seated. Return the daughterboard to the original socket and see if your system boots. If it does boot normally then you should know where the problem lies, either from the modchip itself or your SD card.
I was thinking of doing that. But the flex cable does not pose a problem, no need to unsolder it?
I found the problem the console is dead. when I put the chip in the flex cable it pulled on one of the processor resistors and it was broken.... Thank you for your help
Post automatically merged:
I found the problem the console is dead. when I put the chip in the flex cable it pulled on one of the processor resistors and it was broken.... Thank you for your help
Last edited by jimbow02,
Missing caps on SoC will not prevent your system from booting. It seems you just used too much heat while ripping the flex. The presence of the flex will not cause any harm to your system.
Hi sorry for use your post, but I have the same problem, and the same chip from image,
No sd card logo, with no sd.
Black screen with lights on with sd.
Turn the switch with no sd card, + and - volume put me in sysnand at least.
Seller send without firmware, so I installed 2.73 using usb port on hwfly 2040.
It worked the first time with sd when I installed, I made a nand backup, put in sysnand, asked for rebot to remove old nintendo switch files from sd card and dont turned more on.
I have pressed power once while holding VOL+ & VOL- for a few seconds then I got a blue screen.. Can you tell me is there any way I can fix it?
I have the same issue as above, and when I boot into ofw its black screen
Post automatically merged:
Did you ever figure out the issue?
Last edited by david_enoh,
Similar threads
-
-
-
@
BigOnYa:
He was the ass of gbatemp, everyone knocked on him, I honestly felt bad, even though I was guilty myself, but he egged it all on himself, -
-
-
@
BigOnYa:
I feel like gbatemp should make t-shirts or memorabilia to remember the lost ones. I bet the Polly shirts would sell out quick.
-
-
-
-
@
BigOnYa:
Your correct, Somebody would be guilty and there would be riots, then they storm the gbatemp capitol,
-
@
K3Nv2:
Online or not there are still certain rights that judges would have no issue handing out a warrant over -
-
@
BigOnYa:
Honestly I'm scared to, from you, but ok, lemme turn on vpn, virtual machine, private browser first
-
-
-
@
BigOnYa:
That robot is here somewhere, I hear it moving around at night, but I haven't seen it for months.
-
@
BigOnYa:
Oh that laptop I give to ancientboi, so you been watching him for months, and he's been watching you
-
-
-
-
-
-
-
-
