I have a problem with the UWP build of dolphin on my series x where it partly doesn‘t save my settings and what I changed. It is mainly affecting anti aliasing. When I set it to 0x, 2x or 8x MSAA it just behaves like 0x MSAA. Only when I set it to 4x it actually does someting but I think it is then only 2x. I tried to redo setting up the paths on the Usb drive but it didn‘t change. I also tried to redo setting permissions on the Usb drive but that also changed nothing. This problem occured when I was transferring some files from PC dolphin to my drive. I‘ve had this problem before and I fixed it by setting up the whole dolphin on xbox and usb drive again from the start. I don‘t know why this is occuring and I don‘t want to redo dolphin every time this occurs…
UWP build of dolphin won‘t save settings
- Thread starter Lunk123
- Start date
- Views 2,076
- Replies 0
Similar threads
-
-
-
@
Quincy:
I check brew almost daily (alongside tinfoil sorted on release date) for new games (and cry because of the amount of shovelware and hentai getting released), am unaware of the 2u site -
-
-
-
@
Quincy:
(every one of those fitting after network-, and all play part in the OSI networking layer model)
-
-
-
-
-
-
-
-
-
@
Quincy:
Oh lord, I actually can see Nintendo pulling that one, II for 2 and also a homage to the Wii
-
-
-
-
@
BigOnYa:
Yea i have couple other sites I find Switch titles also and just looked, I don't see it out/leaked yet...(paper mario) -
-
-
-
-
@
Quincy:
Usually when such a big title leaks the Temp will be the first to report about it (going off of historical reports here, Pokemon SV being the latest one I can recall seeing pop up here)
)
